Description

This is a 15 Tooth Front Sprocket for your Tenere 700 which has the rubber backing on each side of the sprocket – the same as the OEM Yamaha sprocket.

This is to assist with quieter running of the chain, and also acts as a basic ‘cush’ drive on your front sprocket.

JT are the leading manufacturer of aftermarket motorcycle sprockets, with the largest and most advanced factory in the world.

Motorcycle Sprockets made the right way…

There’s only one way to make a sprocket that meets the highest quality standards and thats hobbing, machining and drilling. This gives the closest tolerances and most accurate tooth profiles.

…with the right materials…

By sourcing the best quality raw materials for their motorcycle sprockets, JT can ensure the best quality end product.

JT are the only manufacturer to use ultra-durable high carbon C49 steel for their motorcycle sprockets. This is a higher carbon steel than the typical C45 steel used by other manufacturers (including original equipment manufacturers) and so is harder and stronger than many other sprockets on the market.

…to meet or exceed the highest quality standards

Each JT sprocket goes through 10 individual quality control checks before leaving the factory to ensure that it meets or exceeds the highest quality standards for the motorcycle industry. And a good quality sprocket means less wear on the drive chain.

Tenere 700 Sprocket Guide

Rear Sprockets

• 46 Teeth – standard for all Tenere 700 models

Increasing the number of teeth on the rear sprocket will increase acceleration but reduce your top speed.

Reducing the number of teeth on the rear sprocket will decrease acceleration but increase top speed.

Front Sprockets

• 15 Teeth – standard for all Tenere 700  models

Increasing the number of teeth on the front sprocket will decrease acceleration but increase your top speed.

Reducing the number of teeth on the front sprocket will increase acceleration but decrease top speed.